ANTIMONY,USAAnnuari commerciali , directory aziendali

How to Unfurl a Jib Genoa | Lagoon Catamaran Sailing Tips
Here is how to safely unfurl the jib or genoa in a safe and orderly manner This demonstration was done on the Lagoon 42 and is intended to give you confidence in your catamaran handling ability
How to Raise or Unfurl Sails - NauticEd Sailing Blog
Check the jib furling line and make sure it’s laid out and won’t tangle when it flows out Pull (haul) on the downwind jib sheet and the headsail will unfurl and start filling with wind Ideally, keep light tension on the jib furling line to keep it from jamming or overlapping in the drum
How Do You Unfurl a Jib Sail? - Trickyfish
To unfurl a jib sail, start by releasing the jib sheets These are ropes or lines that control the angle and tension of the jib sail By loosening them, you allow for easier handling of the sail during unfurling
Captain Frank Dixon Unfurling the Jib - YouTube
Captain Frank Dixon demonstrates how to unfurl a jib
Unfurling Character: The Telling Cut of the Jib - Galactic Hub
The modern Jib began to take shape in the 16th century with the introduction of the fore-and-aft rig The cut of the Jib is critical in determining its performance, with factors such as aspect ratio, camber, and twist playing a crucial role A well-designed Jib should have a smooth, curved shape, with a moderate camber and a precise twist
proper unfurling furling mainsail and jib, Hunter 41
To unfurl the jib you have to release the furling line, decide which side of the boat you want the jib on, and then pull on the sheet on that side The furling line is the one that runs from the drum at the bottom of the forestay back to the cockpit
Furling and Un-furling the Jib - Massachusetts Institute of Technology
To un-furl, un-cleat the jib furling line, and pull carefully on one of the jib sheets (the jib sheet that will be cleated first) Pull carefully to avoid "halyard wraps" To furl, pull carefully on the furling line, holding on lightly to one of the jib sheets so the furling is nice and tight
The Jib Sail Explained: A Complete Guide - Sailing Ellidah
To use the Jib, you wrap the furler line around the winch, open the jammer, and pull on either of the sheets, depending on which tack you are sailing on You should hold on to the furler line to prevent the sail from unfurling itself uncontrollably, especially in strong winds
How To Reef Your Sails (Mainsail, Jib, Furling, Loose)
Sine the sail isn't attached to the boom, it’s even easier All you have to change are the jib cars To reef a furling headsail: Head upwind to take load off the sail Furl the sail partway to the reefing point Adjust jib cars forward for new sail length Trim sail Removing the reef is just unfurling the sail and moving the jib cars back
Sail question - furling vs hank on jib | SailingForums. com
As long as the integral jib halyard (wire) inside of the jib and the furler and swivel are all in good shape (and the jib pennant is the proper length), furling and unfurling the jib should be almost effortless