|
Spain-EN-EN Azienda Directories
|
Azienda News:
- Configuring Access Control Lists [Cisco Nexus 5000 Series Switches . . .
An access control list (ACL) is an ordered set of rules that you can use to filter traffic Each rule specifies a set of conditions that a packet must satisfy to match the rule When the switch determines that an ACL applies to a packet, it tests the packet against the conditions of all rules
- Solved: SSH access to Nexus 900 - Cisco Community
the access list would be to actually restrict SSH access By default, anyone with IP connectivity can use SSH What are you running into ? Check the guide below for reference: Configuring SSH and Telnet
- SSH Config on Nexus Switch - Network Engineering Stack Exchange
By default, those devices (once online) will be able to connect via SSH to the IP address of the VLAN Interface (10 10 10 1) To block access via SSH to the switch SVI IP addresses, you would need to create access lists that block or restrict traffic to port 22 destined to the switch IP addresses
- Access-List Commands - Cisco Nexus 9000 Series NX-API . . . - Cisco DevNet
Access-List Commands - NX-API CLI is an enhancement to the Cisco Nexus 9000 Series CLI system It improves the accessibility of the CLIs by making them available outside of the switch by using HTTP HTTPS
- Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 6. x
This chapter describes how to configure IP access control lists (ACLs) on Cisco NX-OS devices Unless otherwise specified, the term IP ACL refers to IPv4 and IPv6 ACLs This chapter includes the following sections: An ACL is an ordered set of rules that you can use to filter traffic
- Cisco Nexus 3600 NX-OS Security Configuration Manual
You can use the Secure Shell (SSH) server to enable an SSH client to make a secure, encrypted connection to a Cisco NX-OS device SSH uses strong encryption for authentication The SSH server in the Cisco NX-OS software can interoperate with publicly and commercially available SSH clients
- ssh Access-list - Cisco Community
I want to create an access-list that will allow any host to ssh to the Management address of a switch but, only the Management address Does this look like a clean way to do this?
- Nexus 5000 SSH Configuration Example [Step by Step]
The mgmt0 interface on Cisco NX-OS devices provides out-of-band management, which enables you to manage the device by its IPv4 or IPv6 address The mgmt0 interface uses 10 100 1000 Ethernet switchport access vlan 50 speed 1000 duplex full Example of show SSH key:
- Configuring Access Control Lists
The Cisco Nexus device supports IPv4 for security traffic filtering The switch allows you to use IP access control lists (ACLs) as port ACLs, VLAN ACLs, and Router ACLs as shown in the following table Table 1 Security ACL Applications When a port ACL is applied to a trunk port, the ACL filters traffic on all VLANs on the trunk port
- Cisco Nexus 9k series remote access : r Cisco - Reddit
My company purchased 2 cisco nexus 9k series and I'm trying to set them up so the security engineer can remote into them using ssh I've set other switches before but I'm way out of my depth with this one
|
|