|
France-GM-GM Azienda Directories
|
Azienda News:
- Cinterion BGS3 Hardware Interface Description - ManualsLib
BGS3 needs to be connected to a power supply at the SMT application interface (3 lines each BATT+ and GND) The power supply of BGS3 has to be a single voltage source at BATT+ It must be able to pro- vide the peak current during the uplink transmission RF interface
- Hardware Interface Description - esea. cz
Table 28: Power supply ratings 80 Table 29: Current consumption during Tx burst for GSM 850MHz and GSM 900MHz 81 Table 30: Current consumption during Tx burst for GSM 1800MHz and GSM 1900MHz 82
- BGS3 - Hardware Interface Descriptor - Cinterion | PDF . . .
In the event of undervoltage, it causes BGS3 to power down Undervoltage thresholds are specific to the battery pack and must be evaluated for the intended model When you eval-uate undervoltage thresholds, consider both the current consumption of BGS3 and of the application circuit
- GSM-BGS3-TUB - SEA Praha
GSM-BGS3-TUB can be powered directly from the USB connector or via PWR terminals (the supply voltage must be in the range of 8-30 VDC or 12-30 VAC, the polarity is irrelevant ) The device is protected against overvoltage and has a built in SMD fuse If the external fuse is needed, use 1 25 A fuse at VCC line
- CINTERION BGS3 Specification - IMEI. info
Device type: Modem: GSM: 850 900 1800 1900: Dimensions (H L W): 29 6 x 33 9 x 3 2 mm, vol 3 2 cm³ : LAN: Built-in antena: Antena connector: Plug Play:
- CONTENTS
• Under no circumstances should the voltage on the power connector be exceeded • The manufacturer is not responsible for defects caused by using this device in contradiction with the instruction manual!
- BGS3 CINTERION - Jotrin Electronics
Buy BGS3 CINTERION , Learn more about BGS3 30-4000 MHz SILICON GERMANIUM Gain Block, View the manufacturer, and stock, and datasheet pdf for the BGS3 at Jotrin Electronics
|
|