|
- How do you mount your EZ Pass - Tacoma World
Two strips on the center of the dashboard It is clear and you don't even see it Then mount the EZ-Pass Holds and never fails You could put it the mirror as well This stuff holds pretty firmly We don't do that because we shuttle one EZ Pass between two cars since we don't drive that much
- Failed inspection. Emissions not ready | Tacoma World
If readiness status of all monitors do not switch to “complete,” ensure preconditions are met, turn the ignition switch OFF, then repeat steps “A” through “M ” Completing the Toyota Tacoma drive cycle above should set the emission monitors required to pass the smog check
- Clearing permanent codes - emissions - Tacoma World
It does not clear the non-volitle memory The reason is people would clear their codes just before being smog tested so they could pass even thought the car was not really fixed The codes stay in the background for length of time The smog tester can see that the code was just cleared You won't pass the smog test
- Bypass coolant pipe replacement - Tacoma World
As a registered member, you’ll be able to: Participate in all Tacoma discussion topics; Communicate privately with other Tacoma owners from around the world
- No Mans Land - High Island to Sabine Pass (SE Texas)
Texas Hwy87 used to run between High Island and Sabine Pass - two hurricanes in the 80's and 90's wiped it out and it has never been rebuilt The McFadden marshes north of this area are wildlife sanctuaries and there are no roads, no public access The area between High Island and Sabine Pass is now literally - No Man's Land!
- Leaky gasket on coolant bypass housing. - Tacoma World
GASKET(FOR WATER BY-PASS PIPE) Part Number: 1625875010 Supersession(s): 16258-75010 Fits 4Runner, Tacoma
- Non-JBL speaker audio upgrades - Tacoma World
Is this wired up as a high-pass filter (e g allowing only high frequencies to reach the 3 5") or a low-pass filter (e g blocking high frequencies from reaching the door speaker so that it only has to deal with low frequencies)?
- Camper top to cab seal - Tacoma World
With respect to creating a pass-through for long fly rods into the vehicle cab, why not just use some kind of rigid foam packing material, cut to fit partially opened windows in topper and cab Cut slits in each piece of foam to accommodate rod(s)
|
|
|