|
- Alumacraft Model F | Boating Forum - iboats Boating Forums
Re: Alumacraft Model F The transom plate should identify the boat model and capacity horse power and weight ratings To verify the year and get more information you can use the boat ID# thats stamped on the top of the transom brace and calling Alumacraft at 507-931-1050 or email from their web site
- 12 foot alumacraft specs - iboats Boating Forums
Hi all, Wonder if you might jhave the knowledge I need regarding a 12 ft aluminum alumacraft I'm looking to buy I need some information re: max horsepower as would appear on the capacity plates It's probably from the late 60's to the late 70's No capacity plates are anywhere in the boat
- What year is my Alumacraft? - iboats Boating Forums
Noted that Alumacraft started all their serial # model runs w #100 So if yours is Serial # FD 122, it is likely a 1958, as it was the 22nd FD produced in that run Looks like ALumacraft keeps pretty good records Find that stamped serial # (hopefully on the knee brace) and get in touch w Alumacraft ask them what year it is:
- Can Anyone Help Me ID My Ancient Alumacraft? - Boating Forum
AlumaCraft was the first with this and never had a transom failure Some later 1970's models aqueducts weren't braced, along with other minor boat changes, maybe as rated maximum horsepower was reduced for safety
- Old Original Alumacraft Oars - iboats Boating Forums
I have what I am pretty darn sure are 4 (2 sets) or original 1950-ish Alumacraft oars that came with my boat They are about ohhh 7 - 8ft tall solid pieces They have, what I think is a leather cuff around the oar, and that is wrapped in the metal bracket with the insert, with the
- 2007 Alumacraft Classic 165cs Bilge Pump Question
Well, our local Alumacraft dealer's mechanic suggested it could be buried under the foam too by the manufacturer My thinking is ANY manufacturer that would try something like that on a serviceable part would get shamed out of business in their first year Just sayin'
- Alumacraft Restoration | Boating Forum - iboats Boating Forums
Re: Alumacraft Restoration Jim: I'm working on an old aluminum boat as well I pounded the rivets tight with my daughter holding a bucking bar (block of steel) on the rivets inside Then I used 2 coats of GluVit on all interior seams and rivets per instructions This stuff is no UV stabalized so it needs to be covered or painted
- Alumacraft Maracaibo | Boating Forum - iboats Boating Forums
Re: Alumacraft Re: Alumacraft Well, mine is similar in hull design and weight It is a 1977 Alumacraft Lunker, 16' A small bench up front, a bench in the rear, and a single steering console Its rated for 65hp Currently has a 35, but I just picked up the 2001 Merc 50hp for it Won't get it installed till mid winter some time
|
|
|