|
- Error -1074001424 - NI Community
Most of your subVI's are not readable since they don't come standard with LabVIEW I tried downloading the Keithley 2000 driver from ni com idnet but it also doesn't contain the VI's you're using Would you mind reposting your code along with the needed subVI's as well as providing the documentation and name of the device if you have it?
- RohdeSchwarzNRPZSeriesPowermeters - RadiWiki
RadiMation Error: -1074001424: "Instrument status error" This error is raised when a zero is performed on the power meter, and too much power is present during the zero operation In this case, decrease the applied power and perform the zero operation again
- Can the PXIe-4353 Be Calibrated Based on the Fluke 5730A - NI
When we tried running the calibration, we got error code -1074001424 at step “Testing: Verify CJC Resistance Accuracy 32400 0 Ohm” with a possible reason that the calibrator cannon source that value (which makes sense)
- Solved: Error-1074001424 - NI Community
Solved: While running Cal Exec on an NI-9205 A D convertor, (Dsub) I get this error message when the Cal Exec starts the adjust portion of the test
- Rohde Schwarz NRP-Z24 - RadiWiki
RadiMation Error: -1074001424: "Instrument status error" This error is raised when a zero is performed on the power meter, and too much power is present during the zero operation
- LabVIEW - NI Community
The error message is quite clear: out of range, apparently at the "CALC:MARK1" command! This error message comes directly from your device, it is not a LabVIEW error…
- ECal PNA error code (-1074001424) - NI Community
It looks like you have several subVIs which weren't included I would suggest that you put a probe at the output of each of your subVIs The error propogates through, so this will pinpoint where your problem is
- Getting Started with FLUKE Norma 4000 - Error 1074001424
Turn on I O Trace to capture all of the communication and then compare the captured data to the commands listed in the manual Hello, i am trying to get started with my Fluke Norma 4000 when the following error showed up My computer is connected with an USB RS-232
|
|
|