|
- How to configure COM port? - Microsoft Community
e) Click on the "Port Settings" tab Click the "Advanced" button f) Click on “COM Port Number ” g) Pull down the scrollbar and select “COM1 ” h) Click “OK ” If there is no COM port or Other Device showing in Device Manager you need to enable the serial COM port in the laptop BIOS, assuming the laptop has a COM port
- Changing the Port settings for Serial-USB. - Microsoft Community
If you want to change the port settings, please follow the steps mentioned below: Open Device manager (right click on start button and then on Device manager) Then expand port (COMS LPT) Then right click on Prolific USB-to Serial Comm Port and then on properties Go to port settings and click on Advanced
- How to identify Com Ports in Windows10 - Microsoft Community
Hi Thomas, Thank you for writing to Microsoft Community Forums We understand your concern However, serial bus controller in Device Manager contains USB devices and USB port numbers and it seems COM Ports devices might be hidden, so please follow the steps mentioned below and check if you can see the Com Ports
- How to identify and change the printer port? - Microsoft Community
Close the window and right click the same printer 5 Choose to remove device 6 Go to start search and type in hdwwiz exe and open the application 7 Choose the option "Install the hardware that I manually select from a list 8 Locate printer and choose next 9 Choose to create a new port and choose standard tcp ip port 10
- what is the right settings for outlook for spectrum email
Port: 993 Encryption method: SSL TLS SPA: Checked still working on getting outgoing mail working Hope
- Advance Troubleshooting for Remote Desktop Protocol (RDP) in Windows . . .
Check and Configure RDP Listen Port RDP uses 3389 as the default listen port We can configure the listening port using the Registry Editor Open the Registry Editor and navigate to the following location: HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Terminal Server\WinStations\RDP-Tcp Select the RDP-Tcp key
- Unknown USB Device (Device Descriptor Request Failed) - Driver Error
Try plugging the device into a different USB port, especially the direct-connect port on the motherboard, to troubleshoot the port Replace the USB cable: Sometimes the USB cable may be damaged, replace the cable with a new one to see if that solves the problem Method 2: Power Management
- What port to use when installing a USB printer?
OK, if it not giving you any option but choosing one of that list, pick LPT1 LPT is "parallel" port and is much faster the serial or IR I expect that the USB will "emulate" (fake) LPT for the printer Since this is a printer specific problem, you could try asking the question at the Cannon site
|
|
|