|
- ip inspect . . . little clarification needed - Cisco Learning Network
If you want inspect traffic sourced from the router itself, you would need to change the inspection rule to be: Rack1R1(config) #ip inspect name FW icmp router-traffic Then, the router could ping, the outgoing ICMP would be inspected, and the replies would not be denied at the inbound ACL Best wishes, Keith
- DNS Inspection problem - Cisco Learning Network
JR, This looks like all the configuration is correct DNS inspection checks the packet's PAYLOAD In case of packet trace, the payload I believe is random, so doesn't comply with DNS standard, that's why it fails
- Cisco Learning Network
I think you are looking for router-traffic If you remove the existing tcp inspect and replace it with one like the following, it might work without and acl exception RTR(config) #ip inspect name FWRULE tcp router-traffic Also for the UDP traffic like NTP, DNS RTR(config) #ip inspect name FWRULE udp router-traffic This requires fairly
- inspect icmp - Cisco Learning Network
Configure ASDM to show the commands that are going to be applied to the device, then configure ICMP inspect using ASDM so you can see the command that is being used Its a good way to learn the correct commands
- Class Map [match default-inspection-traffic] - Cisco Learning Network
This relates to the policy map, all those inspect statements are the action take on the traffic identified Matched by the class map I'm concerned about the traffic which will be identified Matched by the class map: Class-map inspection_default match default-inspection-traffic So what traffic is identified Matched in the above class map
- Cisco Learning Network
Loading ×Sorry to interrupt CSS Error
- the default type of class map,, - Cisco Learning Network
inspect Configure CBAC Class Map logging Class map for control-plane packet logging port-filter Class map for port filter queue-threshold Class map for queue threshold stack class-map for protocol header stack specification R2(config) #class-map type test-map ^
- TCP UDP timeouts - Cisco Learning Network
Here is the output of "show run all | begin parameter-map type inspect" from a Cisco router parameter-map type inspect default audit-trail off alert on sessions maximum 2147483647 max-incomplete low 2147483647 max-incomplete high 2147483647 one-minute low 2147483647 one-minute high 2147483647 udp idle-time 30 icmp idle-time 10 dns
|
|
|