|
- Front brake light switch | Steve Saunders Goldwing Forums
imported post I just noticed that my brake lights are not working with the front brake lever They work fine with the rear pedal My repair manual says to replace the front switch, but when I took a close look, there is a "pin" that potrudes from the switch and touches the brake lever when it
- Happy to have found yall !! | Steve Saunders Goldwing Forums
imported post I'm very happy to have joined y'all and thanks for having me! I ride 1985 Interstate bought from original owner and love it!! Thanks again, JB:waving:
- Add On Trike Kit By Tow- Pac | Steve Saunders Goldwing Forums
imported post On February 1, 2008 I was in an auto accident while at work and I broke my back in two places, I am affraid I won't be able to handle the weight of my 1200 if it gets over balanced when starting and stoping especially when my wife is my co-pilot Dang sure don't want let her down
- Clutch not disengaging | Steve Saunders Goldwing Forums
Hello all, I'm new to this forum and new to Goldwings as well I have a 1985 GL1200 and the clutch wont disengage after winter storage I thought the master cylinder was the original problem and had a leak so I rebuilt it with the All balls racing kit Didn’t change anything, so I rebuilt the
- Clutch slave cylinder - Steve Saunders Goldwing Forums
imported post gkiesel (George), I see from that thread you were going to try an avoid moving your engine to remove the slave cylinder by adding bleeding periodically How has that strategy worked? The 84 Aspencade I bought this morning made it 5 miles down the road before the clutch stopped working I won't get a chance to investigate before tonight, but I do not see any fluid in the site
- rectifier regulator too hot | Steve Saunders Goldwing Forums
If you have pretty much stock lights and not a lot of extra stuff on your bike it should be around 14V at 3500 rpm The most likely cause of overheating if you don't have a bunch of lights is the battery Check it out to make sure it holds a full charge and doesn't have a bad cell Since the rectifier gets hot it's likely your stator is putting out plenty of power If the battery checks out
- GL1500 front wheel removal cleaning | Steve Saunders Goldwing Forums
imported post Good morning! I've decided to remove my front wheel to remove minor pitting before it gets to far along I've never done it before and wanted to know if there was anything the forum might want to ad to the procedure Seems like there is always something not mentioned in the book
- Design Differences Between Car and Motorcycle Rim Tire
What? Still not MCT in a run flat? Hmmm A car tire gives me the security of a runflat and gives me much more weight load I think everyone should ride with what they are comfortable with Don't take anyones word for what is right including the manual Try something for yourself and see if it works for you or not
|
|
|