|
- Can I prevent my bathroom mirror from fogging up?
My bathroom is not very large, and especially during winter, the mirror tends to fog up after the shower has been in use Is there something I can do to avoid the mirror fogging up? I seem to vaguely
- 3 Drive Configuration | TrueNAS Community
The drive prices for 16TB drives (specifically Exos) are pretty decent compared to 10TB I think, thus why I want 16TB Are there any downsides to a 3 way mirror? Would it allow two out of the three drives fail without incident? Also if you know any documentation on it that would help a lot Also with RAIDZ, adding drives to a pool later requires resilvering, does a mirror 3 way mirror require
- Managing Pools | TrueNAS Documentation Hub
Extend a ZFS mirror: Add the same number of drives The result is a striped mirror For example, if ten new drives are available, a mirror of two drives can be created initially, then extended by adding another mirror of two drives, and repeating three more times until all ten drives are added Extend a three-drive RAIDZ1: Add another three drives
- Mirroring the Boot Pool | TrueNAS Documentation Hub
Adding a second storage device to the boot pool changes the configuration to a Mirror This allows one of the devices to fail and the system still boots If one of the two devices were to fail, that device is easily detached and replaced When adding a second device to create a mirrored boot pool, consider these caveats: Capacity: The new device must have at least the same capacity as the
- SOLVED - Change stripe vdev layout to mirror - TrueNAS
After confirming going from stripe to mirror was possible I went ahead and built my system with two storage pools An "main" pool with 2 x 8TB drives for bulk storage and a "fast" pool with SSD's At the time of building the "fast" pool I only had access to a single 750GB SSD Knowing that I could extend the pool later, I configured it as a stripe
- Six Metrics for Measuring ZFS Pool Performance Part 1
Traditional RAID-1 mirrors usually only support two drive mirrors, but ZFS allows for more drives per mirror to increase redundancy and fault tolerance All disks in a mirrored vdev have to fail for the vdev, and thus the whole pool, to fail
- Storage Configuration | TrueNAS Documentation Hub
Now that you have logged in to the web interface, it’s time to set up TrueNAS storage These instructions demonstrate a simple mirrored pool setup, where you use one disk for storage and the other for data protection However, there are many configuration possibilities for your storage environment! You can read more about these options in the in-depth Pool Creation article
- Replacing Disks | TrueNAS Documentation Hub
Provides disk replacement instructions that take a failed disk offline and replaces a disk in an existing VDEV The replacement process automatically triggers a pool resilvers
|
|
|