|
- Cummins NHC 250 vs Mack ENDT 673 - SteelSoldiers
There are three military versions of the Mack ENDT-673 engine each one progressively better in performance The last version was usually coupled with the Spicer 5-speed overdrive transmission for best performa
- power limitations of a 250 Cummins? - SteelSoldiers
You're right, my bad On Idaho Motor Pool's web site (where I have been shopping, cause it's close to my place) it says NHC 250 Cummins on all the 5-ton trucks (dump trucks, tractor rigs, and wreckers), all the listings for the M35A2's just say "turbo diesel"
- NHC 250 safe power Mods. - SteelSoldiers
The NHC 250 does not have piston coolers, so you will not be able to run it hard They did make small cams in the 400HP range though You can step up to 290-300 injectors only if you turn up ur fuel pressure you add more stress on the camshaft when you turn up the rail pressure
- Killing NHC 250s -what we have learned killing 3 of them.
The NHC 250’s have become sort of infamous for cavitation caused liner failure We saw some pitting damage in two motors but none on the third Chasing cavitation issues was a red herring for us, it distracted me from what I was doing that was actually killing them
- NHC 250 Commercial Applications - SteelSoldiers
The NHC 250 is a Small Cam Cummins engine of the 855 cubic inch displacement Most of the Small Cam parts should fit on the NHC 250 There should be a CPL number on the data tag on the timing cover on the front left of the engine along with a manufacture date
- Cummins NHC 250 vs 6CTA 8. 3 opinions - SteelSoldiers
CONS -- parts availability, starts better than the NHC-250 in cold weather but still needs a sniff of ether I've had both NHC-250-powered trucks (M929A1, M928A1, M932) and 6CTA 8 3-powered trucks (M936A2, M932A2 and now two M925A2s) While I love the 6CTA 8 3 motor, I would suggest that anyone who is interested stick with the NHC-250-powered
- NHC-250 Fuel Injector Removal Clean Re-install Parts List??
Hey, What are the recommended parts Tips Tricks when removing, cleaning, and re-installing the clogged fuel injectors on an NHC-250? Any guidance Tips from those who have done it would be greatly appreciated! Thanks!! :beer:
- Water Pump Belt replacement - SteelSoldiers
I am in the process of replacing all the belts on my 5 Ton with a Cummins NHC 250 engine I got all of them off except 1 The belt from the crank to the waterpump has no adjustment and I can't figure out how this comes off on I looked at the manual but it appears mine is a bit different than what they show there
|
|
|