|
- How to push my own DNS server to OpenVPN?
I have defined an unbound DNS server on my VPS and it appears to work I need to use the DNS server instead of public DNS servers because some ISPs have blocked public DNS IPs My openvpn conf file
- Connect to OpenVPN using Windows 10 built-in VPN
The OpenVPN protocol is not built-in to Windows OpenVPN is released under the GPLv2 license, which Microsoft won't use The Windows 10 built-in VPN support is not limited to only the protocols shipped by Microsoft (PPTP, L2TP, IPsec, SSTP, IKEv2) It can be extended using 3rd-party VPN provider plug-ins, but to my knowledge this is rare and there are none for OpenVPN, although there is an
- OpenVPN 2. 4. 1 client on Windows 11 cannot disable forced tunneling
I have an OpenVPN host in Azure After connecting with a Windows 11 client, access to the Internet is lost Config file: client proto udp explicit-exit-notify remote [MYVPN] com 1194 dev tun resolv
- How to correctly configure IPv6 with OpenVPN? - Server Fault
Trying to find the OpenVPN configuration which suits my needs I made this script to help myself during the installation on a CentOS system My server config file actually looks like this: port 1194
- OpenVPN issue - TLS key negotiation failed to occur within 60 seconds
I'm configuring an OpenVPN (version 2 3 10) server on a Windows 2012 server but I cannot make it to work The server is behind a router and I opened the 1194 port and created a rule to forward tra
- Fix TLS Error: TLS handshake failed on OpenVPN client
This indicates OpenVPN server do send result to your OpenVPN client via UDP port 1194 But OpenVPN client not receive the result packets Many reasons leads to this result, your ISP block UDP, or company block UDP So change to TCP and try Updating The client cannot receive any packets 8 minutes after successfully connected to server using TCP
- How to route only specific subnet to OpenVPN Server
This was frustrating because there is so much misinformation available: Add these lines to the client ovpn # reject route all traffic through vpn # even if it is configured on the server pull-filter ignore "redirect-gateway" # route only selected traffic through vpn # subnets 10, 20 and 30 route 192 168 10 0 255 255 255 0 route 192 168 20 0 255 255 255 0 route 192 168 30 0 255 255 255 0
- vpn - Should I use tap or tun for openvpn? - Server Fault
What are the differences between using dev tap and dev tun for openvpn? I know the different modes cannot inter-operate What is the technical differences, other then just layer 2 vs 3 operation
|
|
|