|
- PMOS and NMOS symbols - All About Circuits
The PMOS and NNOS symbols in the Figure 1 in the following link is wrong ? Image in question: They're correct and I don't like them I learned about them while I was reading some information from college courses Have no idea how they differentiate between enhancement and depletion mode devices
- Soft start circuit pmos - All About Circuits
Hello, Can anyone explain to how this circuit work? ( i got the picture from youtube but i didnt understood the explanation also searched on the internet and only found little information) I want to know how to select the correct resistors, caps to result to certain delay rise_time Thank you
- PMOS LTSpice issue - All About Circuits
The PMOS circuit is powered by 14VDC and is using a 2n3904 to switch the Gate on the PMOS The gate is going from 14v to 0 v, but the Drain is only going from 13 98v to 13 38v
- How and when to use a NMOS and PMOS as current source sink and voltage . . .
Discussion on using NMOS and PMOS as current sources, sinks, or voltage sources in circuits, addressing challenges and pin configurations
- PMOS CMOS strong 1 0 problem - All About Circuits
I have some problem regarding the strong or weak "1" "0" problem the reason why PMOS produce weak 0, because the PMOS wil turn off at some point the problem I dont know why PMOS will turn off like some point, not like NMOS will pull the voltage down to 0
- PMOS does not fully turn off - All About Circuits
HI I am trying to design a CMOS Inverter NMOS turns on and off as expected However, PMOS does not fully turn off
- Power switch PMOS controlled by button or Microcontroller (or both)
To achieve that, I used a pmos to work as a switch on the power signal and then used a 2 nmos circuit for or signal circuit that controls the pmos In beginning, the pmos gate is at 5V by the pull-up resistor 14 When the user makes a long press on the button, the nmos1 will turn on and consequently put the pmos gate to 0V
- How to use PMOS mosfet? - All About Circuits
Hi readers, is this the correct way to power a PMOS mosfet? I am unfamiliar with PMOS but quite familiar with NMOS Question: How to use PMOS to power a 10 Ohm Load? Thank you I attached LT Spice files below Help me understand by attaching or posting a new schematic :) Thank you and have a nice
|
|
|