|
- 700R4 TV Cable end replacement - GM Square Body
My TV cable hasn't been hooked up for the entire time I have owned my truck, which makes me feel real stupid and makes me real mad at the PO who took the TBI off and F'ed up the conversion The cable is there and appears to pull and retract freely, so I took it by AAmco On Wed and they told me
- Bouncing speedometer | GM Square Body - 1973 - 1987 GM Truck Forum
My speedo was doing great for the longest time Then it started reading just a little slow, then it started bouncing when coming to a stop and when leaving a stop I replaced the cable, and recently replaced the speedometer itself Still the problem persists It's even gotten a bit worse When
- Doug Thorley Tri-Y headers - GM Square Body
I have been keeping an eye open for headers for a while now Just stumbled upon a set of Thorley's for a reasonable price Does anybody have pictures of some installed? Specifically on a 4wd would be nice I can't say I have ever heard anything negative about them Any other review on them
- Motor Mount- How-to? | GM Square Body - 1973 - 1987 GM Truck Forum
It's not a real PITA but it is a slight PITA But for the most part yes, unbolt, raise engine, swap and tight them up I suggest pressure washing the pad top and bottom and the surrounding frame rail Something tells me I’m going to not regret having cleaned those spots
- 79 Interior Colors | GM Square Body - 1973 - 1987 GM Truck Forum
Well, I've finally found the perfect candidate for re-creating my first truck My real first truck was a '79 GMC Heavy Half LWB 2WD Olds 350 Diesel, which had been converted to a Olds 350R gasser Two tone grey over red(or burgundy?) interior My dad bought it new when I was 1 and sold it
- C10 weight? | GM Square Body - 1973 - 1987 GM Truck Forum
Donnieray had it right with the first response, real close to 4k My C10 short stepside weighed in right about 3800 lbs with the stock smallblock After the big block and th400 swap, I weighed the truck on the same scale as I had before and it's now just a tick under 4k It was like 3980 or something If I go digging, somewhere I have a picture of the truck on the scale both times
- suburban doors | GM Square Body - 1973 - 1987 GM Truck Forum
I have some rear cargo doors off a 1990 suburban that are in real good shape for the midwest, a nice full tailgate off a 1988 suburban, a couple sets of rear doors one set power windoe other set crank windows I would like $250 for tailgate and $150 a door I also have lots of other square
- Aftermarket EFI Recommendations - GM Square Body
I'd like to convert my 76 K10 to EFI The systems I have been considering are the Fitech, Sniper and Edelbrock Pro Flo Does anyone have any real world experience installing and using these systems and can provide recommendations? I was quoted around $1800 for the Sniper kit including their
|
|
|