|
- Location of Jack Tire Iron Kit - Ford Ranger Forum
I recently purchased a 2009 Ranger XLT and I have no idea where the tire change kit is located I've found the spare tire under the bed but the kit isn't in the place where the manual says it should be The manual says that it should be behind the passenger seat but there's just storage space back there
- anyone swap an 8. 8 explorer diff to drop rear? - Ford Ranger Forum
Hey guys, Has anyone completed a 8 8 rear swap to drop the rear and lower the front 3" in order to get the 3 5?
- transmission service and coolant in fluid - Ford Ranger Forum
Im in the process of putting back together my ranger thats been sitting a long time and i was flushing the radiator thats been exposed to the weather for a few years I determined i had a bad trans cooler inside the radiator because water was comming out of the trans ports as well when flushing so i ordered a new one
- NO power to Fuel pump - Ford Ranger Forum
I have a Mazda B2500 and I know this is a Ford Ranger Forum but I need some help I have Replaced the fuel pump, as I was replacing it I found a ground broken to the sending unit and this fixed my gas needle issue As I reinstalled everything the engine just turns over
- obd connection not working? - Ford Ranger Forum
Hello everyone Im glad to join and be part of all this, I've been reading your post and have found alot of usefull info But I wanted to know if anyone has ran into this minor prob I just bought a 02 ranger 4 0 SOHC 4x4 The problem is that when I connect my obd2 reader into the plug nothing happens, not even a "there are no fault codes" thing
- 1995 2. 3 Manual. . No Crank. . No Start - Ford Ranger Forum
Hello Forum, So last week the truck was running fine Went to local pizza place, came back to the truck, stuck in the key, pushed in the clutch, no cr
- Long travel width?? - Ford Ranger Forum
Couldn't find the answer I was looking in any other thread Soon I will be putting a long travel kit on my 2000 xlt 4x4 ranger The width would be increased by 4 5 inches in each side I was wondering if anyone had ideas on how to resolve the issue in the rear end Thought about maybe a full size axle? Wheel spacers are not an option Thanks guys
- Vacuum Hub O-ring - Ford Ranger Forum
Hey guys, I’m putting the newly released 5” Rough Country lift kit on my 1999 Ford Ranger There’s a whole page about vacuum operating hub locks and apparently I’m going to need to replace the o-rings in them because it’s a new knuckle The instructions say: “There are two each, of these Ford part numbers, per vehicle:
|
|
|