|
- Boating and Fishing Forum - SEI lower units - The Hull Truth
The Yamaha 150, 175, 200 and 220 use the same gear case from SEI (so I was told by the dealer) so why is 165hp ok on a 220hp motor but only 112hp on a 150? If this was an issue I think they should be worked in and load tested before sale to alleviate any discrepancy regarding operator abuse
- The Hull Truth - Boating and Fishing Forum - sei lower unit
sei lower unit i need to buy a new lower unit for my mercury optimax i've read a lot of good comments about sei aftermarket lowers but on thier website i did not see the option for counter rotating has anyone bought a counter rotating lower unit from them? i tried to call but they close @ 5pm est i will follow up tomorrow but was curious to
- Seakeeper Ride Feedback - The Hull Truth - Boating and Fishing Forum
The Boating Forum - Seakeeper Ride Feedback - Curious to hear from Seakeeper Ride users in the 20-30 ft seems like a great leveling concept and I have heard that it makes your boat feel bigger than it is
- Boating and Fishing Forum - optimax lower unit help - The Hull Truth
For sure the SEI is not a clone of a Verado style gear case but a clone of the older style 3 0L gear case that is what shipped on V6 Optimax motors up to 07 So basically if this motors was a just a little older, it would have gotten the older style gear case that was standard from like 97-07 or there abouts
- Boating and Fishing Forum - The Hull Truth
I ordered a new lower unit (6P3-45300-30-8D) from Yamaha that is going on my 2006 Yamaha F250 I know it's new OEM (not remanufactured)
- Yamaha Lower Unit Question - The Hull Truth
My lower unit went last week on my 2010 Yamaha 250 4 stroke 680 hours Question: Brand new Yamaha LU is $3900
- Boating and Fishing Forum - The Hull Truth
My lift cylinder started leaking after about 8 months on a new dealer installed aftermarket SEI tilt and trim assembly Frustrated as this is the second one, I bought two new OEM Mercury tilt trim assembly, complete units I unbolted the old unit, pulled the pin from main shaft and it seems there is not enough clearance to remove the part
- Mercury 400 v-10 - The Hull Truth - Boating and Fishing Forum
The Boating Forum - Mercury 400 v-10 - So what have we been hearing about Mercury 400 V-10’s Good, Bad, any recurring issues?
|
|
|