|
- Teleworker - Mitel Networks solutions | Tek-Tips
The Teleworker Server (software blade loaded onto a MAS6000) streams the audio and signally to and from the ICP There is not a direct connection between a IP phone deployed as a teleworker and the ICP (hence, you wouldn't need a MAS6000 or the teleworker server)
- Teleworker - Router Firewall settings - Mitel Networks solutions
This port allows a MAS server admin to remotely manage the Teleworker service in the DMZ The MAS server manager panel indicates Remote Teleworker Solution Teleworker Clustering must be enabled on the MAS server and MBG server * Configured upper bound for SRTP on UDP ports is controlled by a setting in the Teleworker Solution Advanced panel
- Teleworker unable to contact server TFTP: Main - Tek-Tips
The Teleworker phone gets its TFTP load from the MBG, not the MCD Sometimes, if the MCD has a newer IP phone firmware and a MCD connected phone is moved to a Teleworker location it may have problems downgrading to an older firmware on the MBG
- Teleworker No Audio - Mitel Networks solutions - Tek-Tips
I have this issue with my Teleworker phones having no audio at all when you call through the public trunk to an external device However, there is audio both ways if you call from a TW set to another TW set, or from an internal ext to a TW set There is also audio both ways when you call from internal ext to the public trunk
- convert phones to Teleworker - Mitel Networks solutions - Tek-Tips
The teleworker instructions that worked in other locations: As phone boots up, press and hold the 7 key Config Teleworker? * for yes press # for new settings press * for ipv4 enter ip address of teleworker gateway press volume down button press * phone reboots phone may download a firmware update phone prompts for a teleworker password, enter it
- Mitel Teleworker - Make calls but no voice through Cisco PIX 2 - Tek-Tips
The Teleworker also communicates with the 3300 on the internal network for its call control and call setup, before the voice stream takes the path as described above It is therefore necessary to allow both the 3300 and internal phones to communicate with Teleworker and also to allow remote phones to communicate to the Teleworker via its public
- How to change Teleworker Public IP? - Mitel Networks solutions
I've read the forums and cannot find a definitive answer on how to change the public IP for Teleworker It seems I should do it in the Mitel Communications Director but I'm not 100% sure I've recently inherited this phone system and am learning as I go Here is our current system info: Release level: 4 1 SP2 Active software load: 10 1 2 16
- Teleworker - One way audio - Mitel Networks solutions - Tek-Tips
I assume this means allow our phone subnet in our inside network to go out to the internet and connect to the public IP of the teleworker server? thanks thread1329-1383134 Yes, this is much better Now we use the box in Server-Only mode and it lives on the DMZ
|
|
|