- How much fluid for a TH-400 - Team Chevelle
Here is an easy one My tranny gasket was about gone so I replaced it I dropped the pan, changed the filter and gasket and then replaced the pan I put four qaurts Dextron Mercron III tranny fluid into it Started motor, let it get hot, shifted through all gears and checked the fluid level Nothing
- th350 kickdown cable hole leak - Team Chevelle
I replaced the little rubber boot gasket at base of kick down cable at tranny, put a bit of fluid, ran it for a bit and slowly but surely began leaking again Not as much a prior to replacing the boot I tightened the bolt nice and tight By chance, does the bolt need some type of sealer? Is it possible it's leaking out of bolt hole?
- The Best Tranny TH400 Re-Build Kit?? - Team Chevelle
Eric Christie Houston Chevelle Club 1965 El Camino - Undergoing frame off resto, build thread (2011- 1970 SS 496 - Cortez Silver, black stripes, black int, forged bottom end, ported 781s, Eddy Air Gap, ProSystem carb, Lunati cam rockers, Sanderson headers, Vintage Air Front runner, Century Transmission - 200R4, 12 bolt, 3 42s
- LS Swap tranny fluid lines - Team Chevelle
My setup is "all" Holley support hardware, 1 25" forward mounts (trying to avoid having to beat on the car for tranny clearance)and an aftermarket crossmember ( 75" lower mount than original) I am hoping this will eliminate me having to massage the tranny tunnel which I refuse to do Any advice would be greatly appreciated
- TH350 Transmission Pan Leaks! - Team Chevelle
I had problems with mine, be careful when replacing this you want to use a lil silicone and a small socket and tap it on easy the pan I would take off and clean real good check the tranny surface and clean real good also the pan surface and smear a lil black rtv around the edges on the pan, stick the gasket and let it set up for about 10 15
- Pilot bushing and Muncie Tranny - Team Chevelle
The tranny is marked as: on case - GM patent # 3088336 then 7-1, then P R07 On slider shift cover plate - 3884685, on the spline input shaft housing - GM14 and 38(or 9)15020 The tranny case to the end of the input shaft measure 6-9 16"
- Decoder for 700r4 tranny casting #s please - Team Chevelle
Can anyone tell me where I can find a 700r4 tranny decoder to find out what this trans came out of I have found casting #'s on the front pump and pass side rear pad Trying to find out if this tranny is the "old" or "new and improved version" of the 700r4 I've heard that the 1987 and up versions are alot better for performance use Thanks
- Replace TH400 output bushing - Team Chevelle
invest in a bushing driver set Install is a lot harder than the removal Without the tool ,and sometimes with, the edges deform , if its really tight fit
|