Why does the data type `intc` in numpy default to 32 bits? np intc is defined as an integer with the size of int in C in the compiler used to build the runtime (see here) In most modern compilers, even in 64-bit toolchains, int is defined to be 32 bits (see here)
How to set up handler for microblaze interrupt? - Stack Overflow I'm trying to use microblaze interrupt to handle with simple gpio button interrupt In the block, only gpio and uart is used as well as interrupt controller Interrupt controller is set for level
numpy - Python range with np. intc - Stack Overflow Yesterday I asked here a question about a weird behavior of python range() I accidentally used range() instead of np arange() But depending on the input int-type it works for mathematical operati
Why interrupts are not shown in proc interrupts? - Stack Overflow If an interrupt did occur, what would you expect to happen? Do you have an interrupt service routine (ISR) written that would handle it? Have you told Linux to enable that interrupt? Normally all this would be taken care of by a device driver Poking registers from user-space doesn't seem the way to go
Linux Device tree, node with multiple interrupt parents In this example, the intc node had an #interrupt-cells value of <3> and the spmi node had an #interrupt-cells value of 4 (meaning that many arguments needed to be used with their respective phandles)
Multibyte UART messages of different lengths using UartLite I have an Arty Board using XUartLite to communicate with my laptop I want to receive multibyte messages of differing lengths The second byte contains the message type and I can then determine ho
Linux 4. 5 GPIO Interrupt Through Devicetree on Xilinx Zynq Platform I can use both intc and axi_gpio_0 as interrupt-parent and it maps to the same IRQ number (I see this from cat proc interrupts) So, ignoring the polarity of the signal, how do I make sure that my registered interrupt is triggered based on the toggling of axi_gpio_0 pin 2? EDIT 2: