|
Canada-0-ESTATES Azienda Directories
|
Azienda News:
- screws backing out of metal roofing - Fine Homebuilding
The washer protects the neoprene from the UV rays of the sun so properly driven screws will last a good twenty years All of this is clearly explained and diagrammed in the instructions available with roofing products
- driving metal roofing screws… - Fine Homebuilding
What is your prefered driver for driving metal roofing screws? Impact driver or drill driver? I'm not looking for vague answers like "you can overdrive screws with the impacter" but real world experiences Thanks in advance!
- Exposed Fastener Metal Roof: Pros Cons? - Fine Homebuilding
I've fixed several exposed-screw roofs with leaks due to shot fastener gaskets, including replacing every gasketed nail in my neighbors roof with longer neoprene screws It was not fun on a 12-pitch The standing-seam look roof we installed was by Fabrall, and needed no special tools for installation Good luck!
- Is Through-Fastened Metal Roofing a Good Idea? - Fine Homebuilding
In the days before cordless drills were invented, through-fastened metal roofing was installed with nails These nails would tend to back out and result in leakage But that risk disappeared when roofers switched to screws with integral neoprene washers
- polycarbonate roofing panels - Fine Homebuilding
As far as SS Screws goes - I haven't used them for roofing before - honestly didn't know they were available but it doesn't suprise me What is important is thet you use the screws that have the built in washer and neoprene washer to self seal and that you do not over drive them Too much pressure on the neoprene will fracture it and let water in
- Metal roofing installation - Fine Homebuilding
The neoprene washer set right takes care of leaks and the oversized hole helps with expansion contraction I use the screws with 5 16" head In the long run, they do better, don't snap off as easy and have more displacement of wood for greater holding ability Welcome to the Taunton University of Knowledge FHB Campus at Breaktime where
- Naming of screws - Fine Homebuilding
In our neighbourhood, B C , Canada they are called "Farm Screws" These are wood screws with a hex head, a concave metal washer and a neoprene washer
- Leaking metal roof - Fine Homebuilding
The metal roofing we use around here usually on sheds barns, uses a screw with a neoprene washer You screw beside the rib on the flat So the metal is tight to the wood and the washer tight to the metal If you screw in the top of the rib the rib can flex
- LOOSE SCREWS - Fine Homebuilding
Just like sheet rock screws, coarse thread screws for going into wood and fine thread for going into metal, you need to be pre-drilling your metal panels and then use a coarse thread screw into the plywood
- Hardi to metal studs - How? - Fine Homebuilding
Okay - I wound up using the neoprene-washer metal roofing screws - they worked great, and cushioned the clamping, so no splitting near the edges - I experimented with countersunk head screws, and they blew out my skinny battens more often than not
|
|