|
Canada-0-LaboratoriesTesting Azienda Directories
|
Azienda News:
- Corrosion Protection Requirements - Master Builders WA
The corrosion protection requirements for breaking surf are applicable to wire ties and structural steel beams as well as the building elements listed for lesser environments, only to a much higher standard
- DHW Technical Guideline - Western Australian Government
The corrosion level (corrosivity) of a site will depend on a number of factors, including proximity to coast, tidal rivers, wetland or industrial areas; exposure to winds and rain; temperature, humidity and micro-climatic conditions
- Corrosion Zones for Abey Masonry Tie Selection
This map represents an indication of corrosion zones within a costal environment As a general rule, the closer to the coast that a dwelling is located, the more corrosive the environment and the greater level of corrosive resistance masonry ties need to provide
- National Construction Code | NCC
This Technical Specification sets out minimum product requirements for appliances and commercial catering equipment connected to the water service and or sanitary plumbing piping
- Durability Rating | Ancon (AU)
Material selection is based on the distance of the structure from the coast and whether that coast opens to a sheltered bay or breaking surf AS 2699 and AS 3700 categorise these areas into zones R1 to R4
- Alternative Tie Down Strap For Coastal Areas (R4 and R3)
In 2013 the Building Commission started a series of compliance inspections for residences throughout WA As part of these structural inspections, they tested samples of tie down straps in coastal areas and found them to be non-compliant with the Australian Standards corrosion protection requirements
- Specifying for marine and industrial environments (updated)
COLORBOND® Ultra steel and SUPERDURA® Stainless steel are available to provide enhanced corrosion protection in more demanding environments, like those by the sea or in areas prone to industrial or chemical fumes and fallout
- Corrosion Protection Requirements - Buildex
Climaseal® 3 Fasteners are suitable for use in Category 3 corrosive environments as described in ISO 9223-2012 and AS4312-2008 Stainless steel and aluminium sheeting are used in highly corrosive environments For this roof sheeting, Buildex® Stainless Steel Fasteners are recommended
- Galvanized coatings for buildings and structural steel
AS 4312 C2 or C3 corrosivity category can be 10km to 50km from a surf coast or 1km to 10km from a sheltered coast and this fits into R2 or R3 durability classification
- ATMOSPHERIC CORROSIVITY CATEGORIES
NCC requirements: BCA Volume 2 defines acceptable corrosion protection requirements for structural steel members, steel framing, lintels, wall ties and metal sheet roofing
|
|